Continuing Program From Search Target; Simple Search Target Definition - Siemens SINUMERIK 840D sl Universal Operating Manual

Machining the workpiece
7.7 Starting execution at a specific point
7.7.2

Continuing program from search target

Press the "CYCLE START" key twice to continue the program from the desired position.
• The first CYCLE START outputs the auxiliary functions collected during the search. The
program is then in the Stop state.
• Before the second CYCLE START, you can use the "Overstore" function to create states that are
required, but not yet available, for the further program execution.
If the set position is not to be approached automatically after the program start, you can also
traverse the tool manually from the current position to the set position by changing to JOG
mode for the REPOS function
7.7.3

Simple search target definition

Requirement
The program is selected and the controller is in Reset mode.
Procedure
150
1. Press the "Block search" softkey.
2. Place the cursor on a particular program block.
- OR -
Press the "Find text" softkey, select the search direction, enter the search
text and confirm with "OK".
3. Press the "Start search" softkey.
The search starts. Your specified search mode will be taken into account.
The current block will be displayed in the "Program" window as soon as
the target is found.
4. If the located target (for example, when searching via text) does not
correspond to the program block, press the "Start search" softkey again
until you find your target.
Press the <CYCLE START> key twice.
Processing is continued from the defined position.
Operating Manual, 07/2021, 6FC5398-6AP40-6BA4
Universal