SWT 3000 Equipment Manual
Display after the connection has been established
The following figure shows an example after the data has been downloaded from a PowerLink
unit, resp. from an PowerLink file or on a new configured PowerLink unit. If the data are being pro-
cessed by a SWT 3000 unit a similar menu is displayed with the designation SWT 3000.
The subordinated levels are displayed when selecting "+".
Figure 21:
The following applies to all menus:
OK:
Cancel:
Apply:
© SIEMENS AG 2008
When selecting „+" the subordi-
nated levels are displayed.
Example of an loaded PowerLink device configuration
Take over the adjustments and close the menu.
Close the menu without taking over the adjustments.
Taking over the adjustments without closing the menu.
For explanation of the different items like Information, Configura-
tion, Adjustments etc. please refer to chapter 4 "Commissioning".
In case of a fault display due to a mismatch between the existing service
program and the version stored in the PowerLink system an upgrade
must be carried out (ref. also to page 20).
Edition p3_3_2x 08/09
Chapter 3: Service program PowerSys
Page - 15