Siemens SINUMERIK 840D sl Universal Operating Manual page 285

The tool creation sequence can be defined differently.
Unloading tool on code carrier
According to the corresponding setting, the unloaded tool on the code carrier is deleted from the
NC memory after reading out the code carrier.
Deleting tool on code carrier
The deletion of the tool can be set differently, i.e. the "On code carrier" softkey is not available.
Universal
Operating Manual, 07/2021, 6FC5398-6AP40-6BA4
3. Press the "New tool" softkey.
The "New Tool - Favorites" window is opened.
4. Position the cursor on the entry "Tool from code carrier" and press the "OK"
softkey.
The tool data is read from the code carrier, and is displayed in the "New
tool" window with the tool type, tool name and possibly with certain
parameters.
5. Press the "OK" softkey.
The tool is added to the tool list with the specified name. If the cursor is
located on an empty magazine location in the tool list, then the tool is
loaded to this magazine location.
1. The tool list is opened.
2. Place the cursor on the tool that you would like to unload from the mag‐
azine and press the "Unload" and "On code carrier" softkeys.
The tool is unloaded and the data of the tool are written to the code carrier.
1. The tool list is opened.
2. Position the cursor on the tool on the code carrier that you want to delete.
3. Press the "Delete tool" and "On code carrier" softkeys.
The tool is unloaded and the data of the tool are written to the code
carrier. The tool is then deleted from the NC memory.
Tool management
12.5 Tool list
285