Performing Limit Comparisons (Limit); Table 3-1 Limit Settling Default Values - Agilent Technologies U1452A User Manual

Performing Limit Comparisons (Limit)

Limit is used to compare the test result with
the chosen settling value. The default settling
values are shown in the table below.
You can set pass condition to be > or < the
value measured.

Table 3-1 Limit settling default values

Function
Voltage measurement
Resistance measurement
Capacitance measurement
Earth-bond resistance test
Insulation resistance test
[1] Absolute value comparison, regardless of polarity.
[2] Limit for capacitance is represented without a unit.
1 Press
2 Press
3 Position the cursor on the > annunciator to change the Limit pass
4 Press
U1452A/U1452AT/U1451A User's Guide
[1]
[2]
to activate Limit.
again to set the comparison value. Use the arrow keys to
position the cursor and to change the value shown.
The most significant digit can be set to a value from 1 to 9. The
remaining two digits can be set to 0, 00, or left blank along with any
unit combination (see
condition (< or >).
to save your changes (or press
changes).

Performing Limit Comparisons (Limit)

Default value
>30 V Auto or Manual
<10 Ω
Auto or Manual
>10 Range locked
<10 Ω
>10 MΩ
Table 3- 1).
Tester Features
Limit
Range
settling range
1 V < LS < 900 V
1 Ω < LS < 90 MΩ
10 < LS < 900
1 Ω < LS < 90 kΩ
Auto
Auto 1 kΩ < LS < 90 GΩ
to discard your
3
57