Installation; Before Installation; Overview - Graco PCF Instructions And Parts

Installation

Before Installation

• Have all system and component documentation
available during installation.
• See component manuals for specific data on compo-
nent requirements. Data presented here applies to
the PCF assemblies only.
• Be sure all accessories are adequately sized and
pressure-rated to meet system requirements.
• Use the PCF control center only with the PCF fluid
plate assembly.
313377B

Overview

The basic steps to install a PCF system are shown
below. See the separate component manuals for
detailed information.
NOTICE
To avoid damaging the PCF system, use at least two
people to lift, move, or disconnect the system. The
system is too heavy for one person to lift or move.
Installation Steps
1. Mount control center.
2. Connect and ground control center.
3. Mount fluid plate assembly.
4. Ground fluid plate assembly.
5. Check ground continuity.
6. Connect fluid lines between fluid module and appli-
cator. Connect fluid supply line and air supply to
module.
7. Plumb filter assembly near air drop site that will be
used for fluid plate assembly.
8. Connect other fluid and air lines to additional system
components as instructed in their manuals.
9. Install cable assemblies.
10. Install Gateway interface.
Installation
17