Graco PCF Instructions And Parts page 21

Mount Four-Valve Breakout Kit 24B693
Follow this procedure if using the four-valve breakout kit.
1. Remove the existing dispense solenoid and cable
from the fluid plate.
2. Install bulkhead fitting (included in the kit) into the
empty hole on the fluid plate.
Connection 1
F . 14: Mount Breakout Kit
IG
3. Connect one end of the extension cable (included in
the kit) to connection 1 on the FCM and the other
end of the cable to the bulkhead fitting.
4. Connect the splitter assembly to the bulkhead fitting.
5. Connect the dispense valve cable(s) to the connec-
tions on the splitter assembly.
NOTE: Up to three additional dispense valves can
be connected to the dispense valve splitter assem-
bly. For each additional dispense valve required
order one dispense valve (258334) and one solenoid
cable (121806).
6. Mount splitter assembly and dispense valves, and
connect air lines as necessary for application.
313377B
GCA Cable
Hole for bulk-
head fitting
Splitter Assembly
Install Command Cable Kit 24B694
Follow this procedure if using the four-valve breakout kit.
1. Install bulkhead fitting (included in the kit) into the
empty hole on the fluid plate. See F
2. Connect one end of the extension cable (included in
the kit) to connection 5 on the FCM and the other
end of the cable to the bulkhead fitting.
3. Connect command cable to bulkhead fitting and
wire to automation controller per the following pinout
table.
FCM Command
Port Cable Wire
Pin # Color Function
1 White Command voltage (0-10 Vdc)
2 Brown No connection
3 Green Dispense trigger (*sourcing input)
4 Yellow No connection
5 Gray Dispense trigger ground
6 Pink No connection
7 Blue Command signal ground
8 Red No connection
NOTE: Command cable inputs are not isolated from
PCF 24 Vdc power.
* To turn on the dispense trigger, connect pin 3 (dis-
pense trigger) to pin 5 (dispense trigger ground).
Installation
. 14.
IG
21