Styles - Graco PCF Instructions And Parts

Styles

The PCF system has the ability to handle up to 255
styles, depending on the selected option. Styles typically
correspond to different components of a specific sys-
tem.
NOTE: The number of available styles depends on
the system configuration. See Models on page 4.
Style 0 is specified for purging only.
For each style, an independent target volume and toler-
ance can be configured. This allows for job-related faults
and logs to be evaluated for each style. The style is read
at the beginning of a job and cannot be changed until
the next job has been initiated.
PCF reads in the styles via the Gateway interface. There
are two 24V digital inputs for the four styles. The style is
read at the beginning of a job and cannot be changed
until the next job has been initiated.
To setup a style:
1. Press to access the style setup fields.
F . 32
IG
313377B
2. Enter the style number in the Style field.
a. Press while in the Style Name field to
enter the Keyboard screen.
F . 33
IG
b. Use the arrow buttons on the user interface to
scroll through each letter. Press to enter a letter
in the style name field. See Keyboard Screen,
page 89, for further details.
c. Press to accept the new value.
3. Enter the target volume in the Volume field, and the
tolerance percentage in the Tolerance field.
4. Press to exit edit mode.
Operation
41