System Setup; Overview - Graco PCF Instructions And Parts

System Setup

System Setup

Overview

The PCF system compensates for temperature, flow, or
pressure fluctuations. However, if there is a hardware
change on the supply system or the dispense material is
changed, the PCF system must be setup again.
After material is loaded into the supply system, set up
the PCF system using the Setup screens. F
the major system setup steps. The following subsections
provide instructions to complete each setup step. Once
these steps are complete the module is ready for opera-
tion.
NOTE: See the User Interface/Display section, page
14, and Appendix A - User Interface Display, page
81, for detailed operating instructions for the display
keypad and each screen.
28
. 21 shows
IG
F . 21
IG
System Setup
Configure Control
Settings
Configure Mode
Settings
Configure Delay
Settings
Configure Flow
Meter Settings
Configure Pressure
Loop Settings
Adjust Pressure
Sensors
Configure Errors
Setup Maintenance
Schedule/Parameters
Configure Gateway
Settings
Setup Styles
Configure Advanced
Settings
End System
Setup
313377B