Install Discrete Gateway Module Interface - Graco PCF Instructions And Parts

Install Discrete Gateway Module Interface

Module Description
The Discrete Gateway Module (DGM) provides a control
link between the PCF system and an automation con-
troller through discrete input and output connections.
This provides the means for remote monitoring and con-
trol by external automation systems.
See System Setup, page 28, for details on controlling
the PCF system through the DGM.
Connect D-Sub Cable
The DGM provides all I/O through the D-Sub cable.
Graco offers two options for connecting a D-Sub cable
to the D-Sub connector (DK). Both options are accesso-
ries and must be ordered separately.
• D-Sub to flying leads cable (123793). See
Appendix B - DGM Connection Details, page
93, for details and cable interface signals.
313377B
• D-Sub cable (123972) and 78-pin breakout
board (123783). See Appendix B - DGM Con-
nection Details, page 93, for details and pin
assignments.
CK
F . 20: Connect D-Sub Cable
IG
DGM Status LED Signals
See LED Diagnostic Information, page 54, for signal
definitions.
Installation
r_24B681_2B9904_2b
27