—
Chapter
4
Network Support
Ethernet Communications
100
Follow the steps below to start Ethernet communications on the 700 Series
Computer. If your system does not contain an 802.11b radio, then
Ethernet networking using DHCP will be selected as the default.
You need to access the Network Driver Interface Specification (NDIS)
tray application to set this communication. From the Today screen, tap
the NDISTRAY icon in the system tray (circled in the following illustration)
to access this application.
A bullet indicates which communications is set for this 700 Monochrome
Computer in the following NDISTRAY pop-up menu. Tap a selection to
change this setting.
700 Series Monochrome Mobile Computer User's Manual