Configuration Parameters; Changing A Parameter Setting - Intermec 700 Series 700 User Manual

—
Appendix A Configurable Settings

Configuration Parameters

Changing a Parameter Setting

290
A configuration parameter changes the way the 700 Monochrome Com-
puter operates, such as configuring a parameter to have the 700 Mono-
chrome Computer emit a very loud beep in a noisy environment. Use any
of the following methods to execute configuration parameters:
S Change Data Collection and SNMP parameters via control panel ap-
plets later in this appendix.
S Send parameters from an SNMP management station. See "SNMP Con-
figuration" starting on page NO TAG.
S Scan EasySet bar codes. You can use the EasySet bar code creation soft-
ware from Intermec Technologies Corporation to print configuration
labels. Scan the labels to change the scanner configuration and data
transfer settings.
Menus of available parameters for each group are listed. Use the scroll bars
to go through the list. Expand each menu (+) to view its parameter set-
tings. Tap a parameter to select, or expand a parameter (+) to view its sub-
parameters.
Note that each parameter or subparameter is shown with its default setting
or current setting in (< >) brackets. Tap a parameter or subparameter to
select that parameter, then do any of the following to change its setting:
Tap Apply to apply any changes. Note that these illustrations are from a
Symbologies parameter.
S Typing a new value in an entry field.
S Choosing a new value from the drop-down list.
S Selecting a different option. The selected option contains a bullet.
S Tap Defaults, then Apply to restore factory-default settings. Tap Yes
when you are prompted to verify this action.
700 Series Monochrome Mobile Computer User's Manual