Intermec 700 Series 700 User Manual page 198

—
Chapter 6 Scanner Support
Parameter
Decoding
Format
Start/Stop
Accepted Start/stop Characters * only
Check Digit
Bar Code Length
182
Note: The following default settings and enumerations apply to both the
IS9CConfig::GetCode39 and IS9CConfig::SetCode39 functions.
Code 39 Default Settings
Default
Active
Standard 43 Character ITC_CODE39_FORMAT
Not Transmitted
Not Used
Any Bar Code Length
Code 39 Enumerations
typedef enum tagCode39Decoding
{
ITC_CODE39_NOTACTIVE = 0,
ITC_CODE39_ACTIVE = 1,
ITC_CODE39_NO_CHANGE = 255
} ITC_CODE39_DECODING;
typedef enum tagCode39Format
{
ITC_CODE39_FORMAT_STANDARD43,
ITC_CODE39_FORMAT_FULLASCII,
ITC_CODE39_FORMAT_NO_CHANGE = 255
} ITC_CODE39_FORMAT;
typedef enum tagCode39StartStop
{
ITC_CODE39_SS_NOTXMIT,
ITC_CODE39_SS_XMIT,
ITC_CODE39_SS_NO_CHANGE = 255
} ITC_CODE39_START_STOP;
typedef enum tagCode39StartStopChars
{
ITC_CODE39_SS_CHARS_DOLLARSIGN,
ITC_CODE39_SS_CHARS_ASTERISK,
ITC_CODE39_SS_CHARS_BOTH,
ITC_CODE39_SS_CHARS_NO_CHANGE = 255
} ITC_CODE39_SS_CHARS;
typedef enum tagCode39CheckDigit
{
ITC_CODE39_CHECK_NOTUSED,
ITC_CODE39_CHECK_MOD43_XMIT,
ITC_CODE39_CHECK_MOD43_NOTXMIT,
ITC_CODE39_CHECK_FRENCH_CIP_XMIT,
ITC_CODE39_CHECK_FRENCH_CIP_NOTXMIT,
ITC_CODE39_CHECK_ITALIAN_CPI_XMIT,
ITC_CODE39_CHECK_ITALIAN_CPI_NOTXMIT,
ITC_CODE39_CHECK_NO_CHANGE = 255
} ITC_CODE39_CHECK_DIGIT;
700 Series Monochrome Mobile Computer User's Manual
Valid Range
ITC_CODE39_DECODING
ITC_CODE39_START_STOP
ITC_CODE39_SS_CHARS
ITC_CODE39_CHECK_DIGIT
0x00–0xFE ITC_BC_LENGTH_NO_CHANGE
// Default
// Default
// Default
// Default
// Default