Aim Symbology Id Defaults - Intermec 700 Series 700 User Manual

—
Chapter 6 Scanner Support

AIM Symbology ID Defaults

Symbology
Codabar
Code 11
Code 39
Code 93
Code128
Interleaved 2 of 5
Matrix 2 of 5
MSI
238
Refer to the official AIM documentation on symbology identifiers for full
information on the different processing options supported.
ID Character Modifier Characters
F 0 Standard Codabar symbol. No special processing.
1 ABC Codabar (American Blood commission)
concatenate/message append performed.
2 Reader has validated the check character.
4 Reader has stripped the check character before transmission.
H 0 Single modulo 11 check character validated and transmitted.
1 Two modulo 11 check characters validated and transmitted.
3 Check characters validated but not transmitted.
A 0 No check character validation nor full ASCII processing. All data
transmitted as decoded.
1 Modulo 43 check character validated and transmitted.
3 Modulo 43 check character validated but not transmitted.
4 Full ASCII character conversion performed. No check character
validation.
5 Full ASCII character conversion performed. Modulo 43 check
character validated and transmitted.
7 Full ASCII character conversion performed. Modulo 43 check
character validated but not transmitted.
G 0 No options specified. Always transmit 0.
C 0 Standard data packet. No FNC1 in first or second symbol
character position after start character.
1 EAN/UCC-128 data packet. FNC1 in first symbol character
position after start character.
2 FNC1 in second symbol character position after start character.
4 Concatenation according to International Society for Blood
Transfusion specifications was performed. Concatenated data
follows.
I 0 No check character validation.
1 Modulo 10 symbol check character validated and transmitted
3 Modulo 10 symbol check character validated but not transmitted.
X 0–F
For symbologies or symbology options not listed, a code character
with the value 0-F may be assigned by the decoder manufacturer
to identify those symbologies and options implemented in the
reader.
M 0 Modulo 10 symbol check character validated and transmitted.
1 Modulo 10 symbol check character validated but not transmitted.
700 Series Monochrome Mobile Computer User's Manual