Configuring 802.11B/G Radio Communications; Configuring Ethernet Communications - Intermec CN4 User Manual

Configuring 802.11b/g Radio Communications

Configuring Ethernet Communications

CN4 Mobile Computer User's Manual
Make sure all components with antennas are at least 30 cm (1 ft)
apart when power is applied. Failure to comply could result in
equipment damage.
Your CN4 has an 802.11b/g radio to transfer data using wireless
communications and supports the TCP/IP network protocols. This
section of the manual assumes that your wireless network is set up,
including your access points.
To use wireless communications in a TCP/IP network
1 Configure these parameters on each CN4 in the network:
• Network name (SSID)
• IP settings (if not using DHCP)
2 Make sure your CN4 is talking to the network and that the
network can see your CN4. For more information, see
Network Connections With iConnect" on page 58.
3 Configure security. For help, see
Security" on page 59.
You connect your CN4 to your Ethernet network with an Ethernet
cable and one of these accessories:
• AD10 single dock with an Ethernet/modem (AA12/AA13) adapter
• AD11 Ethernet multidock
• AA16 Ethernet snap-on adapter
To use your CN4 in an Ethernet network
1 Connect the CN4 to an Ethernet network with an AD10, AD11, or
AA18. Ethernet communication is enabled by default on the CN4.
2 Configure these network parameters:
If you have a DHCP server, enable DHCP.
•
• If you do not have a DHCP server, set these parameters:
a IP address
Chapter 2 — Connecting and Configuring the CN4
"Configuring Wireless
"Managing
53