Save Configuration - Cisco ESW 500 Administration Manual

Managing System Files

Save Configuration

STEP 2
STEP 3
Save Configuration
ESW 500 Series Switches Administration Guide
•
BACKUP — Specifies that firmware is uploaded for a firmware backup.
•
via TFTP — Indicates that the upgrade file is found on a TFTP server.
•
via HTTP — Indicates that the upgrade file is found on a HTTP server.
•
File Type — Specifies the file type of the downloaded file (for TFTP download
only). The possible field values are:
-
Software Image
-
Boot Code
Boot image upgrade is supported by TFTP protocol, but not
NOTE
supported by HTTP protocol.
•
TFTP Server — Specifies the TFTP Server IP Address from which files are
downloaded.
•
Source File — Specifies the file to be downloaded. This field is applicable for
UPGRADE only.
•
Destination File — Specifies the file name on the TFTP server where the
uploaded file is saved. This field is applicable for BACKUP only.
Define the relevant fields.
Click Apply. Firmware upgrade is defined, and the device is updated.
Save Configuration
In the
files on the device.
Save Configuration Page
In the
files from one device to another.
These steps can be done from the Menu-Based CLI or from the web interface.
•
Copy image from TFTP to device
•
Change active image on device
•
Reboot device
— Downloads the Image file.
— Downloads the Boot file.
Page, network administrators can save configuration
, network administrators can copy configuration
14
364