Chapter 11: Configuring Spanning Tree; Defining Stp Properties - Cisco ESW 500 Administration Manual

Configuring Spanning Tree

Defining STP Properties

Configuring Spanning Tree
Defining STP Properties
ESW 500 Series Switches Administration Guide
The Spanning Tree Protocol (STP) provides tree topography for any arrangement
of bridges. STP also provides one path between end stations on a network,
eliminating loops.
Loops occur when alternate routes exist between hosts. Loops in an extended
network can cause bridges to forward traffic indefinitely, resulting in increased
traffic and reducing network efficiency.
The device supports the following Spanning Tree versions:
•
Classic STP — Provides a single path between end stations, avoiding and
eliminating loops.
•
Rapid STP — Detects and uses network topologies that provide faster
convergence of the spanning tree, without creating forwarding loops.
•
Multiple STP — Provides full connectivity for packets allocated to any VLAN.
Multiple STP is based on the RSTP. In addition, Multiple STP transmits packets
assigned to different VLANs through different MST regions. MST regions act as
a single bridge.
The Spanning Tree section contains the following topics:
•
Defining STP Properties
•
Defining Spanning Tree Interface Settings
•
Defining Rapid Spanning Tree
•
Defining Multiple Spanning Tree
The STP Properties Page
STP Properties Page
The
Settings. and Designated Root.
contains parameters for enabling STP on the device.
is divided into three areas, Global Settings, Bridge
11
264