Cisco ESW 500 Administration Manual page 154

Configuring Device Security
Defining 802. 1 x
STEP 3
STEP 4
ESW 500 Series Switches Administration Guide
-
Unchecked
settings above.
•
Authenticator State — Specifies the port authorization state. The possible field
values are as follows:
-
Initialize —
interface moves between an authorized or unauthorized state based on
the authentication exchange between the device and the client.
-
Force-Authorized
Authorized (forward traffic).
-
Force-Unauthorized
Unauthorized (discard traffic).
•
Quiet Period — Specifies the number of seconds that the switch remains in the
quiet state following a failed authentication exchange (Range: 0-65535).
•
Resending EAP — Specifies the number of seconds that the switch waits for a
response to an EAP - request/identity frame, from the supplicant (client), before
resending the request.
•
Max EAP Requests — Displays the total amount of EAP requests sent. If a
response is not received after the defined period, the authentication process is
restarted. The field default is 2 retries.
•
Supplicant Timeout — Displays the number of seconds that lapses before EAP
requests are resent to the supplicant (Range: 1-65535). The field default is 30
seconds.
•
Server Timeout — Specifies the number of seconds that lapses before the
switch resends a request to the authentication server (Range: 1-65535). The
field default is 30 seconds.
•
Termination Cause — Indicates the reason for which the port authentication
was terminated, if applicable.
Modify the relevant fields.
Click Apply. The port authentication settings are defined, and the device is
updated.
— Port authentication according to the Reauthentication
Enables port-based authentication on the device. The
— Indicates the controlled port state is set to Force-
— Indicates the controlled port state is set to Force-
5
143