Step 3: Starting Code Reading - Omron V530-C300E Operation Manual

Basic Operations Using the Console
4-3-3

STEP 3: Starting Code Reading

Procedure
1,2,3...
These parameters can be displayed and changed if necessary
from Reading Settings (Manual). page 73
Scn 0
ABCDE12345
GrayEdgeVal: 18 (11~26), Rev: OFF
The parameters obtained are displayed. These
parameters are used as settings.
Only the read data (ABCDE12345 in this example)
is output to RS-232C.
To turn the teaching function OFF, select Reading Settings
(Manual) from the screen shown in step 5, and press the ENT
Key. The teaching function will be turned OFF by entering the
Reading Settings (Manual) window.
10. This completes the settings.
Enter RUN mode to perform readings. The reading judgment is out-
put to external devices through RS-232C.
1. Confirm that the RUN indicator (orange) is lit.
2. Press the Trigger Switch on the Scanner to read the code.
RUN
Section 4-3
OK 6568ms
Freeze (3)
43