Omron V530-C300E Operation Manual page 121

RUN Mode
When Detail Data is ON:
QR Code (Normal or Pattern Mode)
Set Symbol Color
Right&Left Reverse
Set Gray Edge Value (Normal only)
Set Gray Edge Retry Value (Normal only) Displays the setting of the gray edge retry value.
Set Pixel Skipping (Pattern only)
Set Correlation (Pattern only)
Set Version (Pattern only)
Set Timeout
Error Correction Level
Model
Version
Thresh Value
Pixel/Cell
Error Correction
Data Matrix (Normal or Pattern Mode)
Set Symbol Color
Right&Left Reverse
Set Matrix Size
Set Finder Length (Normal only)
Set Correlation (Pattern only)
Set Timeout
L End Point (Normal only)
Length of Finder
Detailed data of reading codes are displayed.
Set Symbol Color: Black Right&Left Reverse: OFF
Set Matrix Size: 12-12, 0-0
Set Finder Length: 295
Set Timeout: 1000
L End Point (144, 349), (150, 58), (421, 361)
Length of Finder=291,277
Thresh Value=52, 46, 49(0)
Pixel/Cell=24.2, 23.1
Error Correction=0
1234567890
Displays the setting of the symbol color.
Displays the setting of right & left reversal.
Displays the setting of the gray edge value.
Displays the setting for pixel skipping.
Displays the setting for correlation.
Displays the setting of the QR code version.
Displays the setting of the timeout time.
Displays the error correction level read from the code.
Displays the model read from the code.
Displays the version of QR code read from the code.
Displays the threshold value used for decoding.
Displays the pixels/cells read from the code.
Displays the number of blocks for which error correction
was performed when decoding.
Displays the setting of the symbol color.
Displays the setting of right & left reversal.
Displays the setting of the matrix size.
Displays the setting of the finder length.
Displays the setting for correlation.
Displays the setting of the timeout time.
Displays the coordinates of the end point of the finder.
Displays the finder length found when decoding.
RUN
Section 5-2
665ms
Freeze (19)
105