Overview of Operation
1-2
Overview of Operation
4
The Controller can be set either by using a DIP switch on the Control-
ler or by using a Console. This section describes operation using the
DIP switch.
1.
Connect the Controller and Scanner and wire the power supply.
2.
Connect any required external device.
Programmable
Controller
Refer to Section 3 Connecting Peripheral Devices.
Power supply
Controller
TRIG
PWR
RUN
ERR
SCANNER
MONITOR
CONSOLE
RS-232C
V530-C300
2D CODE READER
Cable
Scanner
Refer to Section 2 Installation.
Section 1-2
Personal computer