Omron V530-C300E Operation Manual page 99

SET (Setting) Mode
1,2,3...
Note If the wrong version information is set, the reading can not be per-
1. Select the color of symbol.
Black
(Default set-
ting)
White
2. Select whether Right & Left Reverse of QR Codes is necessary.
ON
OFF
(Default setting)
3. Change the pixel skipping parameters used to search for a model.
(Setting range: 1 to 20; default setting: 4)
The processing time can be reduced if the pixel skipping param-
eters are set to larger values. However, depending on the image,
the search may not be performed since the accuracy is reduced.
After changing the setting, perform a search to confirm whether
the search can be performed correctly.
Pixel Skipping Y
4. Set the correlation threshold value for detecting finder patterns.
Locations with correlation values higher than the threshold are
detected. (Setting range: 1 to 100; default setting: 30)
5. Set the version information for the QR Code to be read. (1 to 6)
The version specified when the model was registered will be dis-
played. (Default setting: Version 1)
formed correctly.
6. Select the timeout time for decoding one reading. (Setting range:
200 to 2,000 ms; default setting: 500 ms)
Black symbol printed on white base.
White symbol printed on black
base.
For reading an image after reflection, or through the
back of a transparent material, such as glass.
For normal reading (from the front of the object)
Pixel Skipping X
Section 5-1
Set the number of pixels
skipped when searching.
83