Before You Begin - Nortel Meridian ITG Line 2.0 Description, Installation And Operation Manual

Page 90 of 302 Installation and configuration summary

Before you begin

553-3001-204 Preliminary 0.10 August 2000
1 Upgrade Meridian 1 X11 software to Release 25.30 or later.
2 Upgrade the M1 keycodes to expand the ISM system limit to support
the number of i2004 Internet Telephones you plan to install. Refer to
Overlay 22 in the M1 System Maintenance Guide (553-3001-511).
3 Verify that you have the latest MAT version 6.67.07 (or later), or OTM
version 1.0 (or later).
Check the M1 ESD website to determine the latest software
a
version.
Refer to Procedure 20, "Navigate through the M1 ESD website" on
page 152.
b Upgrade to the latest version if necessary.
Refer to "ITG MAT 6.67.07 (with update disk)/OTM 1.0 management
PC" on page 159 for further details.
4 Create site name, system name and customer number in the
MAT/OTM Navigator. Specify the correct M1 system type in order for
MAT to prompt for correct TN format.
5 Provision the IP network, ITG line card node and i2004 sets
Choose the DHCP mode : Full, Partial or None(static). For Full
a
DHCP mode, refer to "Configuring DHCP server to support Full
DHCP mode" on page 101.
b Choose the Ethernet connection : desktop hub or switch, or a
separate cable to the equipment closet.
c Determine T-LAN, E-LAN IP address Ethernet connections
from the network IP administrator.
6 Check that the required LAN and WAN networking equipment and
cables are installed. For networking requirements, refer to "IP Network
engineering guidelines" on page 55.
—————————— End of Procedure ——————————