System Initialization; Verifying Initialization; Are Arrow Indicators Flashing; Do You See Select Country - Nortel Meridian Companion Installation And Maintenance Manual

System initialization

Verifying initialization

Are arrow indicators flashing?

Do you see S S S S e e e e l l l l e e e e c c c c t t t t C C C C o o o o u u u u n n n n t t t t r r r r y y y y ?
Once the CMCC is installed and powered, the system begins initialization.
If the indicators on the Administration Terminal do not flash, see
"Troubleshooting the Administration Terminal" on page 168.
When a system is initially installed or after a coldstart, the Administration
Terminal displays Select Country. If it does not display Select Country,
perform a Memory Reset (see page 71).
Invoking country selection enables you to choose Custom or Canada. Selecting
Custom lets you program dual tone multifrequency (DTMF) timing, pulse code
modulation (PCM) coding, and language defaults. If you select Canada, these
items are programmed by default. You can change some other programmable
parameters that are defined by default (such as Dial Delay, Gain values, and side
tone) by entering a general programming session (ƒ••
Once Select Country appears, to indicate initialization is complete, press
^. The display shows the first country selection. Press & or
* until the desired country is displayed. Press OK.
After a country has been selected and confirmed, the system resets.
Meridian Companion Installation and Maintenance Guide
Page 69 of 206
⁄
).