i2004 Internet Telephone power cycle description
Reinstall an i2004 Internet Telephone
Change the TN of an existing i2004 Internet Telephone
ITG Line 2.0/i2004 Internet Telephone Description, Installation, and Operation
Installation and maintenance of i2004 Internet Telephone
3
Follow the steps in "Manual first-time i2004 Internet Telephone
installation" on page 169 to install the footstand, Ethernet cable, power
transformer, handset, handset cord.
4
Power-up the i2004 Internet Telephone.
5
Connect the i2004 Internet Telephone to the LAN using the supplied
Ethernet cable. The i2004 Internet Telephone automatically proceeds
through its DHCP sequence.
6
The i2004 Internet Telephone prompts you for a node number and TN.
Enter the node number and TN on the keypad.
7
Automatic i2004 Internet Telephone configuration is complete.
If the TN has not been previously configured on Meridian 1 or an
invalid TN is used, a message is displayed on the screen of the i2004
Internet Telephone indicating "Invalid TN."
—————————— End of Procedure ——————————
The power cycle is similar to the initial installation. The i2004 Internet
Telephone saves its firmware, IP parameters, Node Number and TN in
memory. As the i2004 Internet Telephone proceeds through a start-up
sequence it does not need to re-enter the IP parameters if they were manually
entered. It does not need to reacquire firmware or prompt the user for Node
Number and TN.
You can reuse an existing, previously-configured i2004 Internet Telephone
on the same Meridian 1. For example, the i2004 Internet Telephone can be
assigned to a new user (new TN) or to an existing user who moved to a new
subnet.
Procedure 27
Changing the TN of an existing i2004 Internet Telephone
1
Power-cycle the i2004 Internet Telephone.
2
During the reboot sequence of a previously-configured i2004 Internet
Telephone, the i2004 Internet Telephone displays the existing node
number and TN for approximately five seconds.
Page 173 of 302