Nortel Meridian ITG Line 2.0 Description, Installation And Operation Manual page 171

Installation and maintenance of i2004 Internet Telephone
5 Power-up the i2004 Internet Telephone.
6 When the Nortel Networks logo appears on the display, immediately
press the four feature keys at the bottom of the display in sequence
from left to right.
7 At the prompt "DHCP Yes/No?", enter "No' for manual configuration.
8 Enter a valid i2004 Internet Telephone IP address, subnet mask, and
router IP address (Gateway) for the i2004 Internet Telephone on the
LAN segment to which it is connected.
9 Enter the Node IP address of the ITG i2004 Line node at the S1 IP
prompt. Continue entering the following information for the S1 server:
• S1 Port: 4100
• S1 Action: 1
• S1 retry count: 10
10 You are now prompted for S2 information. Enter the same IP address,
port number, action and retry count as for connect server 1 (above).
11 The i2004 Internet telephone searches for the connect server. When
the connection is complete, enter the Node ID and the TN or VTN.
12 The i2004 Internet Telephone begins the firmware download. This
takes several minutes. When complete, the i2004 Internet Telephone
resets itself.
13 You are now prompted for the DHCP mode: 0 - Full, 1 - Partial:
Note: Partial DHCP mode does not require any special configuration
of the DHCP server. Full DHCP mode requires special configuration of
the DHCP server to recognize the i2004 Internet Telephone.
14 The Meridian 1 logo, date and time appears on the top line of the
display when the manual configuration is complete.
15 Check for dial tone and the correct DN above the display. Manual
configuration is complete.
—————————— End of Procedure ——————————
ITG Line 2.0/i2004 Internet Telephone Description, Installation, and Operation
Page 171 of 302