Installation and configuration of ITG Line 2.0 node
Install NTCW84JA Large System ITG-specific I/O Panel
Filter Connector
Note: This NTCW84JA ITG-specific Filter Connector is not required
on Option 11C and 11C Mini systems.
For large systems manufactured during the period of 1998-1999 and
shipped in North America, the IPE modules have the NT8D81BA
Backplane to I/O Panel ribbon cable assembly with a non-removable
Filter Connector. The NT8D81BA is compatible with 10BaseT
T-LAN, but if you require a 100BaseT T-LAN, you need to order the
NT8D81AA Backplane to I/O Panel ribbon cable assembly to replace
it. Do not try to install the NTCW84JA ITG-specific Filter Connector
onto the existing non-removable Filter Connector.
Remove existing I/O panel Filter Connector
The standard I/O Filter Connector is shielded metal with a black plastic insert
connector. The NTCW84JA connector uses yellow warning labels to indicate
EMC filtering modifications and which MDF connection points can support
100BaseT connections.
Procedure 6
Remove existing I/O panel Filter Connector
1
Before any of the following steps, remove the ITG pack, or any other
IPE pack, from the IPE shelf card slot corresponding to the I/O Panel
connector to be removed.
Note: Make sure to use the I/O panel connector which corresponds to
the left slot number of the DCHIP card.
2
Remove the NT8D81AA Backplane to I/O Panel ribbon cable
assembly, which is connected to the Backplane side of the existing
block, by releasing the latching pins on the filter block and pulling the
NT8D81AA cable away.
3
Unscrew the existing Filter Connector from the I/O panel. There is one
screw on the lower front of the connector and one screw on the upper
back of the connector. Remove the connector.
ITG Line 2.0/i2004 Internet Telephone Description, Installation, and Operation
CAUTION
Page 115 of 302