Itg Line Card Ip Address Requirements - Nortel Meridian ITG Line 2.0 Description, Installation And Operation Manual

ITG Line card IP address requirements

The IP address information for each card is set in the Configuration tab of
the ITG IP Phones application. The IP address requirements for each card
depend on the Node subnet option.
You must provide an IP address for an E-LAN and T-LAN port. On the
E-LAN, all cards must be on same subnet, which is the same subnet the
Meridian 1 is connected to. On the T-LAN, all cards in a node must be on the
same subnet.
The Management MAC is set in the factory. Use the MOTHERBOARD
Ethernet address (E-LAN address) on the faceplate sticker on each ITG Line
2.0 card.
Separate subnet ITG Line 2.0 card IP address requirements
If you use separate subnets for the ITG Line 2.0 Node (see Figure 6 on
page 48), each ITG Line 2.0 card requires a:
• Management IP address
• Voice IP address
• Management MAC
• Voice LAN gateway IP address
Single subnet ITG Line 2.0 card IP address requirements
Figure 7 on page 49 shows an example of the ITG Node Configuration tab
with IP addresses configured for a single subnet. Because all messages use the
Management LAN, the fields for Voice LAN are greyed-out. If you use a
single subnet for the ITG Line 2.0 Node, each ITG Line 2.0 card requires a:
• Management IP address
• Management MAC
ITG Line 2.0/i2004 Internet Telephone Description, Installation, and Operation
Meridian 1 capacity engineering guidelines Page 47 of 302