Itg Line 2.0 Card Physical Description; Itg Line 2.0 Controls, Indicators And Connectors - Nortel Meridian ITG Line 2.0 Description, Installation And Operation Manual

ITG Line 2.0 card physical description

ITG Line 2.0 controls, indicators and connectors

Faceplate components
ITG Line 2.0/i2004 Internet Telephone Description, Installation, and Operation
The ITG Line 2.0 card (NTZC80AA) plugs into an Intelligent Peripheral
Equipment (IPE) shelf. Each ITG Line 2.0 card occupies two slots.
ITG Line 2.0 cards have an E-LAN management Ethernet port (10BaseT) and
a T-LAN VoIP Ethernet port (10/100BaseT) on the I/O panel. There is an
RS-232 Maintenance Port connection on the ITG Line 2.0 card faceplate and
an alternative connection to the same serial port on the I/O backplane.
Note: Do not connect maintenance terminals to both the faceplate and
I/O panel serial maintenance port connections at the same time.
Figure 3 on page 22 shows the ITG Line 2.0 card faceplate components. The
information in this section describes the components.
NWK
The faceplate connector labeled NWK is a 9-pin, sub-miniature D-type
connector. The connector is not used for the ITG Line 2.0 application.
The NWK connector looks like a 9-pin serial connector. DO NOT
connect a serial cable or any other cable to it. If you install a cable to
the NWK connector, you will disable the T-LAN.
ITG-P LED (Card Status)
The red status faceplate LED indicates the enabled/disabled status of the 24
card ports. The LED is on (red) during the power-up or reset sequence. The
LED remains lit until the card is enabled by Meridian 1. If the LED remains
on, the self-test failed, the card is disabled, or the card rebooted.
Reset switch
Press the Reset switch to reset the card without having to cycle power to the
card. This switch is normally used after a card software upgrade to the card
or to clear a fault condition.
Description
WARNING
Page 21 of 302