Nortel Meridian ITG Line 2.0 Description, Installation And Operation Manual page 251

4 Type in the system name (19 characters, no spaces), location, and
contact person's name for the Meridian 1 site. Use the up and down
arrow keys to move the cursor to the prompt "Press ENTER to
Confirm or ESC to Cancel:" at the bottom of the menu. Press Enter
to confirm and save data to ROM.
5 Enter menu selection number 2 under the "Getting Started" section.
"Menu 2: Modem" is displayed.
6 Type in modem name. Set "Active=Yes". Use arrow keys to navigate
and space bar to toggle values. Set "Direction=Incoming". Type in the
modem router's telephone number for reference. Press Enter to
confirm and save data to ROM.
7 Enter menu selection number 3, "Ethernet Setup", under the "Getting
started" section.
"Menu 3: Ethernet Setup" sub-menu is displayed.
8 Enter menu selection 2, "TCP/IP and DHCP Setup".
"Menu 3.2 - TCP/IP and DHCP Ethernet Setup" is displayed.
9 Use the space bar to toggle "DHCP=None".
10 Under "TCP/IP Setup", type in the IP address and the IP Subnet mask
for the modem router's Ethernet interface on the E-LAN.
11 Toggle "RIP Direction=None". Press Enter to confirm and save data to
ROM, then press Esc to return from the sub-menu to the main menu.
12 Enter menu selection number 12, "Static Routing Setup", under the
"Advanced Applications" section.
"Menu 12 - Static Route Setup" sub-menu is displayed.
Note 1: If firewall security is properly configured in the customer's
Management GW router, and if the modem router is permitted access
over the C-LAN to other ITG nodes on remote E-LANs, define a default
network route pointing to the Management GW IP address on the local
E-LAN. Alternatively, define up to four different static network routes or
host routes in the modem router to limit routing access from the
modem router to the C-LAN.
Note 2: To prevent access from the modem router to the C-LAN via
the Management GW router on the E-LAN, disable RIP by setting "RIP
Direction=None", and remove all static routes or disable a particular
static route by setting "Active=No".
ITG Line 2.0/i2004 Internet Telephone Description, Installation, and Operation
Page 251 of 302