Nortel Meridian ITG Line 2.0 Description, Installation And Operation Manual page 228

Page 228 of 302
Table 34
ITG Line 2.0 ITGL shell commands (Part 5 of 6)
=>Command
IP configuration commands:
NVRIPSet
NVRGWSet
NVRSMSet
NVRIPShow
nvramLeaderSet
nvramLeaderClr
NVRClear
setLeader
clearLeader
Reset commands:
cardReset
isetReset "tn" l s c u
isetReset "tn" c u
553-3001-204 Preliminary 0.10 August 2000
ITG Line card 2.0 maintenance
Sets the IP address in NVRAM.
Sets the default gateway address in NVRAM.
Sets the subnet mask in NVRAM.
Prints the values of the IP parameters that reside in
NVRAM.
Sets the leader bit in NVRAM.
Clears the leader bit in NVRAM, but does not erase the IP
parameters in NVRAM.
Clear IP parameters in NVRAM.
The one command that does all the necessary actions to
make a leader. Sets IP address, gateway, subnet mask,
boot method to static, and leader bit in NVRAM.
The one command that does all the necessary actions to
clear the leader info in NVRAM and set the boot method to
use bootp, thus, making the card a follower.
Performs a warm reboot of ITG Line 2.0 card. The card
must be in the OOS state to use this command.
- large systems
- small systems
Description
Resets the i2004 Internet Telephone