Reset The Operational Measurements; Display The Number Of Dsps; Display Itg Node Properties - Nortel Meridian ITG Line 2.0 Description, Installation And Operation Manual

Procedure 44
Downloading ITG data from the MAT PC
1 At the ITG shell prompt, type: currOMFilePut <hostname, username,
password, directory path, filename> for the current file, or
prevOMFilePut <hostname, username, password, directory path,
filename> for the previous file.
2 At the ITG shell prompt, type: currGKOMFilePut <hostname,
username, password, directory path, filename> for the current file, or
prevGKOMFilePut <hostname, username, password, directory path,
filename> for the previous file.
—————————— End of Procedure ——————————

Reset the operational measurements

This command resets all operational measurement (OM) parameters that have
been collected since the last log dump.
At the ITG shell prompt, type: resetOM .

Display the number of DSPs

This command displays the number of DSPs on the ITG Line 2.0 card.
At the ITG shell prompt, type:

Display ITG Node Properties

This command displays information about an ITG node.
At the ITG shell prompt, type:
The following ITG node information is displayed on the TTY:
• IP addresses for the management and voice subnets
• default router for the management and voice subnets
• subnet mask for the management and voice subnets
• SNMP manager
ITG Line 2.0/i2004 Internet Telephone Description, Installation, and Operation
ITG line card 2.0 administration
DSPNumShow
IPInfoShow
Page 199 of 302