Installing The Water Pump Cover; Installing The Starter Drive - Husqvarna FE 350 2015 Repair Manual

ENGINE
18
18.5.18

Installing the water pump cover

18.5.19

Installing the starter drive

Position the clutch cover.
• Info
I
Ensure that the shaft seal rings of the water pump and the crankshaft are
not damaged.
O.
-
Remove screw
-
Mount screw @ with the washer but do not tighten yet.
Guideline
I
Screw, clutch cover
(D
-
Mount screws but do not tighten yet.
Guideline
I
Screw, clutch cover
-
Tighten all screws in a crisscross pattern.
-
Mount the two-part water pump impeller
-
Mount and tighten nut @ .
Guideline
Nut, water-pump wheel
-
Mount the water pump cover with the seal ring.
• Info
I
Ensure that the dowel pins are seated properly.
(D
-
Mount screw but do not tighten yet.
Guideline
I
Screw, water pump cover
8
-
Mount screws but do not tighten them yet.
Guideline
I
Screw, water pump cover
0
-
Mount screw with the washer but to not tighten yet.
Guideline
I
Screw, water pump cover
-
Tighten all screws in a crisscross pattern.
-
Grease the O-ring of the starter motor.
-
Position the starter motor.
0,
-
Mount screws but do not tighten yet.
Guideline
I
Screw, starter motor
I
M6x25
I
M6x40
O.
M6 5Nm
(3.7 lbf ft)
I
M6x25
I
M6x40
I
M6x25
185
110 Nm (7.4 lbf ft)
110 Nm (7.4 lbf ft)
Loctite 243
® ™
110 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)