Husqvarna FE 350 2015 Repair Manual page 32

6
FORK, TRIPLE CLAMP
I
-
Turn the fork. Have the entire filling quantity of fork oil available.
Oil capacity per
fork leg
-
Add some of the fork oil while pulling out and pushing in the piston rod numerous
times.
Guideline
I
Fork oil quantity
-
Mount and tighten hydrostop unit @.
Guideline
I
Hydrostop unit
-
Clamp the fork vertically.
-
Add the remaining quantity of fork oil.
202091-10
-
Pull out the piston rod and push it back in numerous times while pressing it to
one side slightly.
✓ Air bubbles emerge and the cartridge is bled.
-
Keep bleeding until no more air bubbles emerge.
✓ The piston rod moves out automatically to the middle of the total stroke
distance.
• Info
I
When fully bled, the correct air chamber length is achieved automatically.
-
Position spring.
-
Pull the spring down. Mount screw cap@.
• Info
I
When assembling, ensure that the screw caps are correctly mounted
according to the hydrostop needles.
Rebound damping side - red hydrostop needle, screw cap with
mark REB.
Compression damping side - silver hydrostop needle, screw cap with
mark COMP.
-
Pull the spring down. Mount the open end wrench on the hexagonal part.
-
Hold the open end wrench. Tighten screw cap @.
I Guideline
Screw cap on piston rod
I
Special socket (T14047)
635 ml Fork oil (SAE 4) (48601166S1)
(21.47 fl. oz.) (a p. 284)
I
51 o ml (17.24 fl. oz.)
I
M30x1
I
M8x0.75
(a p. 298)
30
I I
40 Nm (29.5 lbf ft)
18 Nm (13.3 lbf ft)