Installing The Lower Triple Clamp - Husqvarna FE 350 2015 Repair Manual

6
FORK, TRIPLE CLAMP
6.26
Installing the lower tri
�
\
I...:
- t t ,
1... t
;:;:;,;
8-8
0- -8
Main work
-
Clean the bearing and sealing elements, check for damage, and grease.
I
High viscosity grease (il!.!J
-
Position the lower triple clamp with the steering stem. Mount the upper steering
head bearing.
-
Check whether the upper steering head seal
8
-
Mount protective ring
-
Position the upper triple clamp with the handlebar.
8
-
Mount screw but do not tighten yet.
-
Position the clutch line in the guide above the voltage regulator.
-
Position the fork legs.
0
✓ Bleeder screws
• Info
I
The compression damping is located in the left fork leg
adjusting screw). The rebound damping is located in the right fork leg REB
(red adjusting screw).
Grooves are milled into the side of the upper end of the fork legs. The sec­
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
(FE EU/ AU/US)
-
(D.
Tighten screws
Guideline
Screw, bottom triple clamp
(FE 350S US)
-
(D.
Tighten screws
Guideline
Screw, bottom triple clamp
p. 286)
O
is correctly positioned.
and 0-ring (D.
are positioned toward the front.
MS
MS
33
(white
COMP
15 Nm
(1 U lbf ft)
15 Nm
(1 U lbf ft)