Installing The Fork Protector; Performing A Fork Service; Disassembling The Fork Legs - Husqvarna FE 350 2015 Repair Manual

6
FORK, TRIPLE CLAMP
6.10 Installing the fork rotector
6.11

Performing a fork service

,.
t
0
8
i
f !
0
• "'
'
II
ij
oa
elo
Disassemblin the fork le s
Info
The steps are identical for both fork legs.
Main work
-
Position the fork protector on the left fork leg. Mount and tighten screws
Guideline
I
Remaining screws, chassis
-
Position the fork protector on the right fork leg. Mount and tighten the screws.
Guideline
I
Remaining screws, chassis
C00565-10
Finishing work
-
Install the fork legs.
-
Install the front wheel.
-
Install the headlight mask with the headlight.
-
Check the headlight setting.
Condition
The fork legs have been removed.
-
Disassemble the fork legs.
-
Remove the spring.
-
Disassemble the cartridge.
-
Disassemble the piston rod.
Disassemble the hydrostop unit.
-
Disassemble the seal ring retainer.
-
Check the fork legs.
-
Assemble the seal ring retainer.
-
Assemble the hydrostop unit.
-
Assemble the piston rod.
Assemble the cartridge.
-
Assemble the fork legs.
201926-01
Condition
The fork legs are disassembled.
-
Note down the current state of rebound damping
fork leg).
-
Note down the current state of compression damping
of left fork leg).
Fully open the adjusters of the rebound and compression damping.
(� p. 15)
(il!ll p. 94)
(il!ll
(il!ll p. 127)
(� p. 17)
(� p. 19)
(� p. 20)
(il!ll p. 21)
(il!ll p. 22)
(� p. 23)
(� p. 23)
(� p. 24)
(� p. 25)
(a p. 25)
(a p. 27)
(� p. 28)
O.
10 Nm (7.4 lbf ft)
110 Nm (7.4 lbf ft)
p. 89)
O
REB (red adjuster of right
fj
(white adjuster
COMP
17