Handlebar,Controls; Handlebar Position; Adjusting The Handlebar Position; Adjusting The Basic Position Of The Clutch Lever - Husqvarna FE 350 2015 Repair Manual

HANDLEBAR,CONTROLS

7
7.1 Handlebar osition
Ad"ustin the handlebar osition
Warning
Danger of accidents
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a result.
-
Change the handlebar if the handlebar is damaged or bent.
7.3
On the upper triple clamp, there are two holes at a distance of
I Hole distance
The holes on the handlebar supports are placed at a distance of
I Hole distance
The handlebar supports can be mounted in four different positions.
101859-10
A repaired handlebar poses a safety risk.
-
Remove screws
lay it to one side.
• Info
I
Cover the components to protect them against damage.
Do not bend the cables and lines.
-
Remove screws
-
Place the handlebar supports in the required position. Mount and tighten
8.
screws
101860-10
Guideline
Screw, handlebar holder
• Info
I
Position the left and right handlebar holders evenly.
-
Position the handlebar.
• Info
I
Make sure the cables and wiring are positioned correctly.
-
Position the handlebar clamps. Mount and tighten screws
Guideline
I
Screw, handlebar clamp
• Info
I
Make sure the gap width is even.
-
Adjust the basic setting of the clutch lever to your hand size by turning adjusting
0-
screw
• Info
I
Turn the adjusting screw clockwise to increase the distance between the
clutch lever and the handlebar.
Turn the adjusting screw counterclockwise to decrease the distance
between the clutch lever and the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply any force.
Do not make any adjustments while riding!
e
1 15 mm (0.59 in)
G,
I 3.5 mm (0.138 in)
O.
Take off the handlebar clamps. Take off the handlebar and
8.
Take off the handlebar supports.
M10
f)
to each other.
0
from the center.
40 Nm
Loctite ® 243
(29.5 lbf ft)
O
evenly.
I
20 Nm (14.8 lbf ft)
38
™
I