Husqvarna FE 350 2015 Repair Manual page 31

6
FORK, TRIPLE CLAMP
-
Slide on the lower sliding bushing
-
Mount the upper sliding bushing (D.
Info
Do not use a tool; pull the ends apart slightly by hand.
-
Warm the outer tube in area
Guideline
1
so c
(122 °F)
0
-
Slide the outer tube onto the inner tube.
-
Hold the lower sliding bushing with the longer section of the special tool.
I
Mounting tool (T14040S)
-
Push the sliding bushing all the way into the outer tube.
-
Position the support ring.
-
Hold the seal ring with the shorter section of the special tool.
I
Mounting tool (T14040S)
-
Push the seal ring and support ring all the way into the outer tube.
-
Mount lock ring @.
Info
The lock ring must engage audibly.
O.
-
Mount dust boot
-
Mount fork protection ring G).
-
Lubricate the O-ring. Slide the cartridge all the way into the fork leg.
I
Fork oil (SAE 4) (48601166S1)
0.
6)
of the lower sliding bushing.
(I!:! p. 298)
(I!:! p. 298)
(� p. 284)
29