Installing The Rear Wheel - Husqvarna FE 350 2015 Repair Manual

WHEELS
14
14.7.2

Installing the rear wheel

Warning
Danger of accidents
-
Always keep the brake discs free of oil and grease.
-
Clean the brake discs with brake cleaner when necessary.
-
Remove spacers
Oil or grease on the brake discs reduces the braking effect.
Main work
-
Check the wheel bearing for damage and wear.
If the wheel bearing is damaged or worn:
-
Change the rear wheel bearing.
Clean and grease shaft seal rings
I
Long-life grease
-
Insert the spacers.
-
Lift the rear wheel into the swingarm, position it, and insert wheel spindle @.
-
Mount the chain.
✓ The brake linings are correctly positioned.
-
Position chain adjuster @). Mount nut
-
Make sure that chain adjusters @) are fitted correctly on adjusting screws
-
Check the chain tension.
-
Tighten nut
Guideline
I
Nut, rear wheel spindle
• Info
I
The wide adjustment range of the chain adjusters (32 mm (1 .26 in))
enables different secondary ratios with the same chain length.
Chain adjusters@) can be turned by 180
-
Operate the foot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
Finishing work
-
Remove the motorcycle from the lift stand.
8.
(�
O
and bearing surface
(� p. 286)
8,
(!!l p. 98)
8.
p. 103)
f)
of the spacers.
but do not tighten it yet.
I
M20x1.5 I 80 Nm (59 lbf ft)
° .
(!!l p. 11)
97
0.