Husqvarna FE 350 2015 Repair Manual page 159

ENGINE
18
-
Press the crank pin out of the lower crank web.
-
Press in the new crank pin
✓ Oil hole
X If the oil holes are not correctly aligned, the conrod bearing will not be sup­
plied with oil.
-
Blow compressed air through the oil channel to check that it is clear.
302912-10
-
Mount the new connecting rod
Info
Thoroughly oil the bearing
-
Position special tool (3 on the press.
Pressing tool for crankshaft, complete (75029047000)
Insert for crankshaft pressing tool (77229008000)
-
Insert the crank web with connecting rod and bearing. Position the second crank
web.
-
Position special tool @ with the heel pointing down.
I
Insert for crankshaft pressing tool (77229008000)
Press in the upper crank web as far as possible.
• Info
I
The press mandrel must be positioned over the crank pin.
-
Take the crankshaft out of the special tool and check that the connecting rod can
move freely.
-
Measure the axial play between the connecting rod and the crank webs with spe­
@).
cial tool
I
Feeler gauge (59029041100)
Connecting rod - axial play of lower
conrod bearing
If the specification is not reached:
-
Correct it so the dimension is equal to the specified value.
308662-10
Finishing work
-
Check the crankshaft run-out at the bearing pin.
(D
as far as possible.
8
is aligned with oil hole@).
C,.
@).
(!.;!I p. 291)
(a p. 292)
(!!;!I p. 293)
(a p. 293)
0.20 ... 0.45 mm (0.0079 ... 0.0177 in)
(a p. 158)
157