Changing The Swingarm Bearing - Husqvarna FE 350 2015 Repair Manual

SHOCK ABSORBER, SWINGARM
9

Changing the swingarm bearing

Info
These operations are the same on both swingarm bearings.
-
Position the engine sprocket cover and mount it in the holder.
Mount and tighten screws
Guideline
I
Screw, clutch slave cylinder
Mount and tighten screws
I Guideline
Remaining screws, chassis
-
Position the brake caliper and pull it back.
-
Position the brake line in the guide.
Finishing work
-
Install the rear wheel. (a
-
Remove the motorcycle from the lift stand.
Preparatory work
-
Raise the motorcycle with a lift stand.
-
Remove the rear wheel.
-
Remove the swingarm. (a
8 .
0.
p. 97)
(a p. 11)
(li!:!l p. 11)
(ta p. 96)
p. 63)
65
10 Nm (7.4 lbf ft)
I I
25 Nm (18.4 lbf ft)