Changing The Rear Wheel Bearing - Husqvarna FE 350 2015 Repair Manual

WHEELS
14
14.7.11

Changing the rear wheel bearing

-
Remove fittings (D. Take off the rear sprocket.
-
Position the new rear sprocket. Mount and tighten the fittings.
Guideline
Nut, rear sprocket screw
-
Slide new engine sprocket
-
Mount the new chain.
-
Connect the chain with connecting link
Guideline
The closed side of the chain joint lock must face in the direction of travel.
-
Install the rear wheel. (!1ll
-
Have an assistant operate the rear brake.
-
Mount and tighten screw
Guideline
Screw, engine sprocket
-
Position the engine sprocket cover.
-
Mount and tighten screw
Guideline
I
Screw, clutch slave cylinder
-
Mount and tighten screw (!}.
Guideline
I
Remaining screws, chassis
Finishing work
-
Remove the motorcycle from the lift stand.
Preparatory work
-
Raise the motorcycle with a lift stand.(� p. 11)
-
Remove the rear wheel. (�
MB 35 Nm
(25.8 lbf ft)
0
onto the countershaft.
C,.
p. 97)
8
with washer.
M10 60 Nm
(44.3 lbf ft)
O.
(a p. 11)
p. 96)
103
Loctite ® 2701
TM
Loctite 2701
® TM
110 Nm (7.4 lbf ft)
I I
25 Nm (18.4 lbf ft)