Checking The Clutch - Husqvarna FE 350 2015 Repair Manual

ENGINE
18
18.4.34

Checking the clutch

,
-
Check the pressure piece
If there is damage or wear:
-
Change the pressure piece.
8
-
Place push rod on a level surface and check for run-out.
If there is run-out:
-
Change the push rod.
8
-
Check spring retainer
If there is damage or wear:
-
Change the spring retainer.
-
Check the pretension ring
If there is damage or wear:
-
Change the pretension ring.
0
-
Check spring washer
If there is damage or wear:
-
Change the spring washer.
-
Check the thrust face of pressure cap
If there is damage or wear:
-
Place two compensating disks or similar aids next to the timing chain tensioner
piston. This ensures that, when pressed in, the piston cannot go in all the way.
Guideline
I
Thickness of the compensating disks
-
Release the timing chain tensioner.
✓ The detent mechanism engages and the piston remains in place.
Final position of the piston after
engagement
200172-10
Info
This position is necessary for installation.
If the timing chain tensioner is now pressed again and is only extended
a maximum of half way (it is prevented from extending completely). This
locks the detent mechanism and the timing chain tensioner can no longer
be squeezed together. This function is necessary in order to ensure suffi­
cient timing chain tension even at low oil pressures.
O
for damage and wear.
for damage and wear.
8
for damage and wear.
for damage and wear.
C)
for damage and wear.
I
2 ... 2.5 mm (0.08 ... 0.098 in)
3 mm (0.12 in)
304690-10
170