Installing The Primary Gear; Installing The Force Pump - Husqvarna FE 350 2015 Repair Manual

ENGINE
18
18.5.9

Installing the primary gear

Installing the force pump

18.5.10
-
Position timing chain guide rail (D.
-
Mount and tighten screw
Guideline
Screw, timing chain guide
rail
Position timing chain tensioning rail
-
Mount and tighten screw 0).
Guideline
Screw, timing chain ten­
sioning rail
O.
-
Position primary gear
✓ The wide tooth of the primary gear engages in the wide recess of the
crankshaft.
f)
✓ Markings and G) are aligned.
-
Set the crankshaft to top dead center and lock it with screw
-
Mount and tighten nut (D.
Guideline
Nut, primary gear
-
Oil the oil pump shaft, internal rotor and external rotor before assembly.
O.
-
Position force pump
• Info
I
The rounded side of the force pump faces the engine case.
8
-
Mount oil pump shaft
-
Mount pin (D.
-
Position the oil pump cover.
f)
✓ Marking faces upward.
-
Mount and tighten screws
Guideline
Screw, oil pump cover
0.
-
Insert pin
C,.
M6 10 Nm
(7.4 lbf ft)
0.
M8 15 Nm
(11.1 lbf ft)
M18LHx1 .5 100 Nm
(73.8 lbf ft)
from below.
C,.
M5 6Nm
(4.4 lbf ft)
180
Loctite 243
® ™
Loctite 243
® ™
8.
Loctite 243
® ™
Loctite 243
® ™