Changing The Hydraulic Clutch Fluid - Husqvarna FE 350 2015 Repair Manual

19
CLUTCH
Changing the h draulic clutch fluid
Warning
Skin irritation Brake fluid causes skin irritation.
-
Keep brake fluid out of the reach of children.
-
Wear suitable protective clothing and safety glasses.
-
Do not allow brake fluid to come into contact with the skin, the eyes or clothing.
-
Consult a doctor immediately if brake fluid has been swallowed.
-
Rinse the affected area with plenty of water in the event of contact with the skin.
-
Rinse eyes thoroughly with water immediately and consult a doctor if brake fluid comes into contact with the eyes.
-
If brake fluid spills on to your clothing, change the clothing.
Warning
Environmental hazard
-
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable
regulations.
Hazardous substances cause environmental damage.
(FE EU/ AU/US)
-
Move the clutch fluid reservoir mounted on the handlebar to a horizontal posi­
tion.
-
Remove screws
Remove cover @ with membrane
(FE 350S US)
-
Move the clutch fluid reservoir mounted on the handlebar to a horizontal posi­
tion.
-
Remove screws
Remove cover @ with membrane
-
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4
- e.
On the clutch slave cylinder, remove bleeder screw
syringe
(FE EU/ AU/US)
-
Inject the liquid into the system until it escapes from openings
ter cylinder without bubbles.
Now and then, extract fluid from the master cylinder reservoir to prevent over­
flow.
-
Remove the bleeding syringe. Mount and tighten screws bleeder screw.
Correct the fluid level of the hydraulic clutch.
I
Guideline
Fluid level below container rim
-
Position the cover with the membrane. Mount and tighten the screws.
O.
(D.
O.
(D.
8
with the appropriate hydraulic fluid.
(!!l p. 289)
(!!l p. 284)
14
mm (0.16 in)
197
0
and mount bleeding
(D
of the mas­