Changing The Rear Wheel Bearing - Husqvarna FS 450 2019 Repair Manual

14.8.10

Changing the rear wheel bearing

-
Position the engine sprocket cover.
-
Mount and tighten screw
Guideline
Screw, clutch slave
cylinder
-
Mount and tighten screw @.
Guideline
Remaining screws,
chassis
Finishing work
-
Remove the motorcycle from the lift stand.
-
Install the air filter box cover.
Preparatory work
-
Raise the motorcycle with a lift stand.
-
Remove the rear wheel.
Main work
O.
-
Remove shaft seal ring
- @.
Remove lock ring
-
Remove shaft seal ring (D.
-
Using a suitable tool, press bearing
the outside.
0.
-
Remove spacing tube
O
with the washer.
M6 10 Nm (7.4 lbf ft)
M8 25 Nm (18.4 lbf ft)
(� p. 12)
(� p. 95)
(� p. 12)
(� p. 124)
8
out from the inside to
WHEELS 14
..
133