Configuring Roclink 800 Communications Parameters - Emerson Micro Motion 3711 Configuration And Use Manual

Setting Up Communications
4.5.2

Configuring ROCLINK 800 communications parameters

If you will connect to the Model 3711 using the Connect function, ROCLINK 800 communications
parameters must be configured. Because ROCLINK 800 can be used to connect to multiple devices,
communications parameters are saved separately for each device.
Note: PC COM port parameters are automatically adjusted by ROCLINK 800 as required.
To configure ROCLINK 800 communications parameters for the Model 3711:
1. Start ROCLINK 800 software, but do not connect to a device.
2. Using the Device Directory window in ROCLINK 800 (see Figure 2-2), right-click the device
defined for your Model 3711 (see Section 2.6), then click
Communication Parameters dialog box shown in Figure 4-3 is displayed.
Figure 4-3
3. In the General panel, set connection parameters as required (see Table 4-3). Note:
•
Tag
connecting to. The values entered here must match the values configured for the
Model 3711 in the Device Information dialog box (see Section 3.4).
•
Host Address
formatting responses to requests.
30
ROCLINK 800 Communication Parameters dialog box – General panel
, , and
Device Address
and
Host Group
identify the Model 3711 that you are
Device Group
will be used by the Model 3711 to identify this host when
Micro Motion
. The ROCLINK 800
Properties
®
Model 3711 Gas Flow Computers