Emerson Micro Motion 3711 Configuration And Use Manual page 81

Configuring I/O
Figure 7-9 Discrete Inputs – Alarms panel
Table 7-8 Discrete Inputs – Alarms parameters
Parameter Description
RBX Alarming Specifies the type of Report By Exception alarming for this
input:
• Disabled – No RBX alarming.
• On Alarm Set – RBX alarm generated when the discrete input
enters an alarm condition.
• On Alarm Clear – RBX alarm generated when the discrete
input leaves an alarm condition.
• On Alarm Set and Clear – RBX alarm generated when the
discrete input enters an alarm condition and when the discrete
input leaves an alarm condition.
Low Alarm Not applicable to the Model 3711.
High Alarm Not applicable to the Model 3711.
LoLo Alarm Not applicable to the Model 3711.
HiHi Alarm Not applicable to the Model 3711.
Rate Alarm Not applicable to the Model 3711.
Alarm Deadband Not applicable to the Model 3711.
Configuration and Use Manual
Comments
If RBX Alarming is enabled, a
communications port must be
configured for RBX alarming. See
.
Section 4.6
73