Chapter 14 Administration; About This Chapter; Initializing The Model 3711 And Managing Memory; Using The Jumpers - Emerson Micro Motion 3711 Configuration And Use Manual

Chapter 14
Administration
14.1

About this chapter

This chapter discusses the following topics:
•

Initializing the Model 3711 and managing memory

• Model 3711 memory structure
• Meter default values
• Event log
• Alarm log
• Advanced communication and system controls
• Using the optional dial-up modem
• Managing user programs
• Managing device configuration data and files
• Updating firmware and user programs
• Upgrading hardware
14.2 Initializing the Model 3711 and managing memory
You can initialize the Model 3711 by using jumpers or by using ROCLINK 800.
• If you use jumpers:
- You do not have to be connected to the Model 3711.
- Only a warm start and a communications reset start are available.
• If you use ROCLINK 800:
- You must be connected to the Model 3711.
- Several different types of restart are available.
14.2.1

Using the jumpers

Two jumpers on the face of the Model 3711 can be used to start and stop the unit and to determine the
startup mode. These jumpers are shown in Figure 2-1.
To start or stop the Model 3711:
1. Unscrew the cover from the front of the unit.
2. Insert the power jumper (the bottom jumper) into the desired slots:
• ON (center and right)
• OFF (left and center)
Configuration and Use Manual 157