Table of Contents
Advertisement
Administration
1. Click
Figure 14-7
2. Set the options at the top as desired:
•
If
specified file before the update.
•
If
downloaded to the Model 3711 after the update.
Note: To ensure that the Model 3711 is restored to its current configuration, enable both options.
3. Click the upper
and/or restore functions.
4. Click the lower
update.
5. Click
6. The loading process typically takes several minutes. When the loading is complete, the
specified configuration file will be downloaded (if requested), and actions are recorded in the
event log. Then, ROCLINK 800 automatically reconnects to the Model 3711.
7. Check the configuration. If necessary, reload it.
8. Check FSTs. If necessary, reload or restart them.
168
Utilities > Update Firmware
Update Firmware dialog box
Save Device Configuration
Restore Device Configuration
button to specify the configuration file that will be used for the save
Browse
button to specify the image (binary) file that contains the firmware
Browse
.
Start
. The dialog box shown in Figure 14-7 is displayed.
is enabled, the current configuration will be saved to the
is enabled, the specified configuration file will be
Micro Motion
®
Model 3711 Gas Flow Computers
Advertisement
Table of Contents
Troubleshooting
