A&D TM-2441 Instruction Manual page 98

To connect the recorder to a dedicated peripheral using the USB cable
Step 1. Open the micro USB terminal on the recorder.
Connect the accessory USB cable.
To start data communication with a dedicated peripheral
Step 1. Connect the micro USB cable between
the recorder and the dedicated
peripheral.
Step 2. The buzzer sounds and
is displayed on the LCD.
The data communication enters
standby mode.
Step 3. Carry out analysis using the
dedicated peripheral. The data
communication only enters active
online mode during USB
communication.
To stop data communication with a dedicated peripheral
Step 1. Remove the cable in the standby mode.
Connect the micro USB
Standby
online mode
78
Micro USB terminal
USB cable
mode
Active